With my Kenmore washer(110.26712693)the spin cycle leaves the clothes too wet. I run a second spin cycle and the clothes are good to go to the dryer. There is never any water setting in the tub. With light/small loads it works o.k., the larger the load the wetter the clothes.
I have replaced the pump, coupler, and clutch. The motor and centrifugal switch check out good with the multi-meter for continuity. I understand there is a high spin function but I don't know how to test if this
is the problem. Can anyone explain how to test the high speed function? Or could it be something else?
Thanks,
dmend
I have replaced the pump, coupler, and clutch. The motor and centrifugal switch check out good with the multi-meter for continuity. I understand there is a high spin function but I don't know how to test if this
is the problem. Can anyone explain how to test the high speed function? Or could it be something else?
Thanks,
dmend