Appliance Questions and Answers Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Appliance Questions and Answers Forum

Post your Questions in the Forums about Appliance Repair and Service Questions and get Free Advice and Repair Help


You are not connected. Please login or register

Appliance Questions and Answers Forum » General Questions for MrBill » Affinity Washer Mdl ATS7000

Affinity Washer Mdl ATS7000

2 posters

Go down  Message [Page 1 of 1]

1Affinity Washer Mdl ATS7000 Empty Affinity Washer Mdl ATS7000 11/25/2009, 21:34

grandpah-fixit



Need to figure out how to remove the Door Lock assy. Error Code E47. Measurement was 1315 ohms Grey to Black on Connector Block. Not sure if its the PTC or Door Lock Assy. Blk to Red was open as well as the other side of the circuit.
Thanks,
Gramps

MrBill

MrBill
Admin

Basically its pretty simple. Remove the top cover of the machine. Two screws on the back of it, it slides back then off.

From there remove the two screws on the front of the door lock itself.

Make sure the machine is unplugged now. Now reach down from the top and fish out the lock assemble. Get it to where you can unplug the wires and remove it!

Good Luck

Bill

http://www.applianceoutletservice.com

Back to top  Message [Page 1 of 1]

Appliance Questions and Answers Forum » General Questions for MrBill » Affinity Washer Mdl ATS7000

Permissions in this forum:
You cannot reply to topics in this forum